JH Industries Copperloy EDGE-OF-DOCK SEL Series, Installation & Owner'S Manual

Page: 10 / 42

10
JH INDUSTIRES INC.
WELD
DOCKLEVELER
MOUNTING PLATE
DOCK
(CONCRETE)
MODEL: TPBL24
BEVELED
FORMED ANGLE
REMOVE CONCRETE AS
REQUIRED (2” MAX IN EACH
DIRECTION). FILL IN WITH
CONCRETE AS REQUIRED
WELD
DOCKLEVELER
MOUNTING PLATE
DOCK
(CONCRETE)
MODEL: TPKL24
KINKED
FORMED ANGLE
SHIM AS
REQUIRED
CURB
ANGLE
SHIM AS
REQUIRED
WARNING
!
FIGURE 7
FIGURE 6
INSTALLATION,
CONTINUED
INSTALLATION WITH
FORMED ANGLE
1. Lay formed angle on top of dock.
2. If using a beveled formed angle (Model: TPBL24)
position formed angle on dock making sure both
legs are tight against top and face of dock and
skip to step 7.
(See Figure 6).
3. If using a kinked formed angle (Model: TPKL24)
position formed angle in desired position on dock
edge and mark location of back of angle on floor
of dock.
(See Figure 7).
4. Slide formed angle forward 2” and mark location
of back of angle on floor of dock.
5. Remove angle and cut a groove in concrete 1/2”
deep between lines marked in steps 3 & 4.
6. Place formed angle on dock making sure back
edge of leg on top of dock is recessed in groove
and both legs are tight against top and face of
dock. Increase depth or width of groove as
required.
7. Install anchor bolts in the formed angle. All anchor
bolts to be a min. strength in shear of 10,000lbs.
Force and a min. of 6,000lbs. Pull out strength in
uncracked concrete. When bolts are tight in the
concrete, remove nuts, cut bolts flush with top of
formed angle and plug weld bolts to formed angle.
All anchor bolts must be installed in accordance
with the manufacturer’s instructions. Improper
installation may result in death or serious injury.
Do not install anchor bolts in cracks or expan-
sion joints in concrete. Installation in cracks or
expansion joints may cause the anchors to come
loose and pull out. Use of improperly installed
anchor bolts may result in death or serious injury.
NOTICE!
All anchor bolts to be a min. strength in shear of
10,000lbs. Force and a min. of 6,000lbs. Pull out
strength in uncracked concrete.
8. Proceed to GENGERAL INSTALLATION section
on pages 13 & 14 of this manual.