Jets™ 25MBA Vacuumarator™ pump
Tel. +47 70 03 91 00
www.jetsgroup.com
Product No. 200025004
Doc. Rev.: 22 (2021-06-08)
15
21
Position the O-ring
℻
on the
pressure chamber.
22
Position the rotor
ℼ
on the shaft.
23
Fit the rotor housing
ℽ
.
24
Insert the O-ring
℻
.
25
Position the end flange
ℹ
on the
rotor housing
ℽ
.
26
Tighten the four stay bolts
℺
in a
cross formation.
27
Place the stationary knife in the
assembly.
2.11 Warning
Beware of sharp edges.
28
Secure the stationary knife in
place with the four screws
(M5x12) using Loctite® 222 or an
equal quality locking compound.
29
Insert the rotating knife and split
sleeve in the assembly.
It is recommended to use an
alignment tool when fastening the
rotating knife. Contact Jets Vacuum
AS or your local approved supplier
for alignment tool details.
2.11 Warning
Beware of sharp edges.
30
Apply locking compound to the
hex bolt and secure it with 30Nm
torque. Use Loctite® 243 or an
equal quality locking compound.
31
Turn the center hex screw on the
macerator to ensure that all parts
rotate freely without obstruction.
Visually check that there is a
clearance between the rotating knife
and the stationary knife.
32
Position the O-ring
ℷ
.
