Jet JWS-22CS, Operating Instructions And Parts Manual

Page: 10 / 24

10
Table Ring Removal and Installation
To remove the table ring(s):
1. Remove any collet or spindle assembly in the
spindle.
2. Lower the spindle assembly completely.
3. Loosen and remove the three 1/4" x 5/8” cross
point screws from the ring.
4. Lift ring.
5. Install the rings back into the table using the
“witness” line (alignment indicator line) on the
table and the table rings.
Operation
Spindle Control
To raise or lower spindle:
1. Loosen spindle lock handle counter clockwise
(A, Fig. 8). The handle is spring-loaded; by
pulling out you can adjust the positioning.
2. Raise or lower spindle to desired height by
turning handwheel (B, Fig. 8).
3. Tighten spindle lock handle clockwise.
Using the Fence as a Guide
Shaping with the fence is the safest and most
satisfactory method of working. This method should
always be used when work permits. Almost all
straight work can be used with the fence.
1. For most work, where a portion of the edge of the
work is not touched by the cutter, both the front
and rear fences are in a straight line, as shown in
Figure 9.
2. When the shaping operation removes the entire
edge of the work (i.e. jointing or making a full
bead), the shaped edge will not be supported by
the rear fence when both fences are in line as
shown in Figure 10. In this case, the work piece
should be advanced to the position shown in
Figure 10 and stopped.
Figure 8
Figure 9
Figure 10