Jet JWS-22CS, Operating Instructions And Parts Manual

Page: 8 / 24

8
Arbor Removal and Installation
All adjustments to the machine must be made
with the power off and unplugged from the power
source!
Failure to comply may result in serious injury!
The safety shield has been removed for
illustration purposes only! Never operate the
shaper without the safety shield!
Failure to comply may result in serious injury!
The arbor is mounted to the main spindle with a draw
bar and a nut. Use the following procedure to remove
the arbor. Reverse the steps to install the arbor.
1. Disconnect the machine from the power
source.
2. Raise the spindle fully by turning handwheel
clockwise.
3. Open the door by pulling out the latch (A, Fig. 1).
Open the door, and release the latch.
4. Pull the spindle locking mandrel (A, Fig. 2) out,
and turn to lock the main spindle.
5. Loosen the draw bar nut (B, Fig. 2) with a 14mm
box wrench or adjustable wrench and remove the
nut (A, Fig. 3).
6. Loosen the hex nut (A, Fig. 4) with the arbor
wrench (B, Fig. 3).
7. Loosen and remove the spindle (C, Fig. 3).
8. Remove the nut (A, Fig. 4) and draw bar (D, Fig.
3) from the spindle.
9. Pull the spindle locking mandrel out and turn to
release the main spindle.
10. Close the door.
Figure 1
Figure 2
Figure 3
Figure 4