Jet JWS-22CS, Operating Instructions And Parts Manual

Page: 12 / 24

12
3. The collar between cutters method, shown in
Figure 18, has both the advantages and
disadvantages of the first two methods. This
method is used primarily where both edges of the
work are to be shaped.
Starting Pin
Using the starting pin should only be attempted
by advanced users! If you have never used this
method before, it is recommended you get
training from a qualified person who is
knowledgeable in starting pin shaping!
Failure to comply may cause serious injury!
The starting pin is placed in one of the threaded holes
in the table:
1. Work should be placed in the first position using
the guide pin as support, as shown in Figure 19.
Then swing the work into the cutter as shown in
the second position. The work will now be
supported by the collar and starting pin.
2. After the cut has been started, the work is swung
free of the starting pin and rides only against the
collar as shown in the third position in Figure 20.
Always feed against the action of the cutter.
Lubrication
To insure easy movement when raising and lowering
spindle, occasionally apply a drop of light oil on
outside of spindle cartridge.
Spindle cartridge bearings are pre-lubricated and
sealed. They need no further care.
Figure 18
Figure 19
Figure 20