Jet JWS-22CS, Operating Instructions And Parts Manual

Page: 9 / 24

9
Collet Installation
1. Disconnect machine from the power source.
2. To set up the shaper for collet use, remove the
arbor and clean the spindle taper (Fig. 5).
3. Raise the spindle fully by turning handwheel
clockwise.
4. Pull the spindle locking mandrel out (A, Fig. 2)
and turn to lock the main spindle.
5. Screw the collet assembly onto the spindle
threads 9Fig. 6)
6. Insert a router bit into the collet.
7. Tighten the collet nut with the arbor wrench.
8. Pull the spindle locking mandrel out and turn to
release the main spindle.
Fence Adjustments
1. Adjust fence halves by loosening lock knob (A,
Fig. 7), turn knurled knob (B, Fig. 7) to adjust
fence in or out, and tighten lock knob.
2. Adjust spindle guard height by loosening wing nut
(C, Fig. 7), sliding guard up or down to desired
height, and then tightening wing nut.
3. Adjust spindle guard depth by loosening two lock
knobs (D, Fig. 7), moving spindle guard to desired
position, and then tightening two lock knobs.
4. Hold down clamps can be adjusted for height by
loosening hex socket cap screws (E, Fig. 7),
adjusting the hold down clamps to the desired
height, and tightening the hex socket cap screws.
Figure 5
Figure 6
Figure 7