Jet JWS-22CS, Operating Instructions And Parts Manual

Page: 7 / 24

7
Unpacking and Cleanup
1. Finish removing all contents from the shipping
container. Do not discard any shipping material
until the shaper is set up and running.
2. Inspect contents for shipping damage and report
any damage to your distributor.
3. Clean all protected parts with kerosene. Do not
use gasoline, paint thinner, or any cellulose-based
solvent. These will damage painted surfaces and
melt plastic.
Tools Required for Assembly
10mm Wrench
14mm Wrench
Contents of the Shipping Container
1 - Shaper
Accessory Package
1. Dust Chute
1. Miter Gauge
1. Switch Lock Bracket
1. ¾” Spindle Assembly
1. ¼” Collet w/Nut
1. ½” Collet w/Nut
1. Collet
Nut
1. Spanner Wrench
1. 8mm Hex Wrench
1. 6mm Hex Wrench
1. 3mm Hex Wrench
Dust Chute Assembly
1. Install dust chute to the fence body with two ¼” x
½” hex cap bolts.