Sliding table adjustment:
The sliding table is adjusted ex works.
The sliding table must be aligned to run parallel to the sawblade.
The table surface must be approximately 0,1 ‐ 0,4 mm higher than
the machine table (Fig 12‐2).
Loosen the bolts (A) and adjust with screws (B).
Fig 12‐2
Mounting the sliding table support legs (2x):
Fig 13
Mounting the telescopic swing arm:
Fig 14
Mounting Cross cut Table:
Place the crosscut table (A, Fig 16) onto telescopic arm support rod
(B).
Fig 15
Slide two M8x70 carriage bolts with T‐blocks into the T‐slot of the
sliding table, attach with 2 wing nuts.
Adjust M12 hex nuts (C) to bring the cross cut table into same
plane with sliding table and machine table.
Move the sliding table and check plane again.
Note:
In case the crosscut table changed in height, this must be
eliminated on the swing arm rotate axis (Fig 16).
Fig 16
Mounting Cross cut Fence
Drop the cross cut fence (C, Fig 17) into the forward or rear guide
pin hole.
Tighten the knurled nut.
Attach with T‐bolt and locking handle (G).
Turn the "Z" lock plate (F) to quick aligning the fence to square.
Turn the star type screw and clamp the fence in position.
Slide the flip stop (D) into the fence.
