GB ‐ ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET‐machine. This manual has been prepared for the
owner and operators of a
JET JTSS‐1600 Panel saw
to promote safety during installation, operation and maintenance procedures. Please
read and understand the information contained in these operating instructions and the accompanying documents. To obtain maximum life
and efficiency from your machine, and to use the machine safely, read this manual thoroughly and follow instructions carefully.
…Table of Contents
1. Declaration of conformity
2. Warranty
3. Safety
Authorized use
General safety notes
Remaining hazards
4. Machine specifications
Technical data
Noise emission
Dust emission
Contents of delivery
Description of machine
5. Transport and start up
Transport and installation
Assembly
Dust connection
Mains connection
Starting operation
6. Machine operation
7. Setup and adjustments
Changing saw blade
Mounting the raving knife
Mounting the saw guard
Rising and tilting sawblade
Setup of scoring sawblade
Sliding table setup
Crosscut table setup
Crosscut fence setup
Mitre fence setup
Rip fence setup
8. Maintenance and inspection
9. Troubleshooting
10. Environmental protection
11. Available accessories
1. Declaration of conformity
On our own responsibility we hereby declare that this product
complies with the regulations* listed on page 2. Designed in
consideration with the standards**. CE type examination***
performed by****.
2. Warranty
The JPW (Tool) AG guarantees that the supplied product is free
from material defects and manufacturing faults.
This warranty does not cover any defects which are caused, either
directly or indirectly, by incorrect use, carelessness, accidental
damage, repair, inadequate maintenance or cleaning and normal
wear and tear.
Any warranty details (i.e. warranty period) can be found in the
General Terms and Conditions (GTC) that are
integral part of the contract. These GTC can be viewed at the
website of your dealer or sent to you upon request.
JPW (Tool) AG reserves the right to make changes to the product
and accessories at any time.
3. Safety
3.1 Authorized use
This machine is designed for sawing wood, wood derived materials
as well as similar to be machined hard plastics only.
Machining of other materials is not permitted and may be carried
out in specific cases only after consulting with the manufacturer.
No metal workpieces may be machined.
The workpiece must allow to safely be loaded, supported and
guided.
No cuts without using the rip fence, the 90° fence or the sliding
table may be performed.
No submerged cuts by removing the riving knife and/or saw guard
may be performed.
The use of a power feeder is not considered.
The proper use also includes compliance with the operating and
maintenance instructions given in this manual.
The machine must be operated only by persons familiar with its
operation, maintenance and repair and who are familiar with its
hazards.
The required minimum age must be observed.
The machine must only be used in a technically perfect condition.
When working on the machine, all safety mechanisms and covers
must be mounted.
In addition to the safety requirements contained in this operating
instruction and your country’s applicable regulations, you should
observe the generally recognized technical rules concerning the
operation of woodworking machines.
