Jenn-Air JES8750BA Series, Service Manual

Page: 27 / 67

© 2006 Maytag Services
16026926 27
To avoid risk of electrical shock, personal injury or
death; disconnect power before servicing, unless
testing requires power.
Disassembly Procedures
4. Label and disconnect wire terminals from cooling fan.
5. Remove screws securing fan to range chassis.
6. Reverse procedure to reinstall cooling fan.
Hidden Bake Element Replacement
(Select Models)
1. Remove power from unit.
2. Open oven door and remove rack(s).
3. Remove screws securing hidden bake element cover.
4. Remove hidden bake element cover by sliding cover
toward the rear of the oven cavity while lifting up on
front of cover.
5. Remove screws securing bake element to rear of
cavity wall.
6. Pull element forward to allow for labeling and
disconnection of wire terminals.
7. Remove element support clips.
8. Reverse procedure to reinstall bake element.
Bake Element Replacement (Select Models)
1. Remove power from unit.
2. Open oven door and remove rack(s).
3. Remove screws securing bake element to rear of
cavity wall.
4. Pull element forward to allow for labeling and
disconnection of wire terminals.
5. Remove element support clips.
6. Reverse procedure to reinstall bake element.
Broil Element Replacement
1. Remove power from unit.
2. Open oven door and remove racks.
3. Remove screws securing broil element to top and
rear of oven cavity.
4. Pull broil element forward to allow disconnection of
wiring from terminals.
5. Reverse procedure to reinstall broil element.
Downdraft Blower Motor Removal
(Select Models)
1. Remove power from unit.
2. Remove bottom access panel, see "Bottom Access
Panel Removal" procedure.
3. Disconnect ducting to allow for downdraft blower
motor removal.
4. Label and disconnect wire terminals.
5. Remove screws securing motor assembly.
6. Reverse procedure to reinstall downdraft blower
motor (select models).
Indicator Light Removal
1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wires from indicator light.
3. Squeeze the two tabs on the indicator light body and
gently pull to release from control panel.
4. Reverse procedure to reinstall indicator light.
Oven Sensor
Meat
Probe
Broil Element
Bake
Element
Cooling
Fan
Transformer
Meat Probe Receptacle Replacement
(Select Models)
1. Remove power from unit.
2. Remove range from installation position, see
“Removing and Replacing Range” procedure.
3. Remove front side trim, see "Front Side Trim
Removal" procedure.
4. Remove screws securing side panel to chassis and
main top.
5. Open oven door and remove nut securing meat probe
receptacle to oven cavity.
6. Label and disconnect wire terminals from receptacle.
7. Gently slide meat probe receptacle through oven
cavity.
8. Reverse procedure to reinstall meat probe receptacle.
Back Panel Removal
1. Remove power from unit.
2. Remove range from installation position, see
“Removing and Replacing Range” procedure.
3. Remove screws securing back panel to unit.
4. Slide back panel up and out to remove.
5. Reverse procedure to reinstall back panel.
Cooling Fan Replacement
1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove back panel, see "Back Panel Removal"
procedure.