Jenn-Air JES8750BA Series, Service Manual

Page: 26 / 67

26 16026926
© 2006 Maytag Services
Disassembly Procedures
To avoid risk of electrical shock, personal injury or
death; disconnect power before servicing, unless
testing requires power.
7. Label and disconnect wiring to elements (select
models).
8. Remove screws securing element mounting brackets
to maintop assembly (select models).
9. Gently remove elements from mounting brackets to
prevent damage to glass top (select models).
10.Reverse procedure to reinstall maintop assembly.
Control Panel Assembly Removal
1. Remove power from unit.
2. Remove burner switch control knobs.
3. Remove front screws securing control panel to
chassis.
4. Remove screws located on the left and right sides of
the control panel.
5. Grasp control panel on the far left and right sides and
gently pull the control panel out and down.
NOTE:
The electronic control located in the control
panel is a sensitive item, handle gently.
6. Label and disconnect wire terminals.
7. Remove infinite switch control knobs, infinite
switches, indicator lights, rocker switches, and
electronic control/clock (as necessary) and transfer to
the new control panel.
8. Reverse procedure to reinstall control panel.
Electronic Control Replacement
1. Remove control panel, see “Control Panel Assembly
Replacement” procedure, steps 1 through 5.
2. Remove screws securing electronic control bracket to
control panel.
3. Label and disconnect terminal wiring from electronic
control.
4. Slide electronic control down and out of bracket,
applying slight outward pressure to the inside edges
of the electronic control bracket.
5. Reverse procedure to reinstall electronic control.
Infinite Switch Removal
1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wire terminals from infinite
switch.
3. Remove knob on infinite switch being replaced.
4. Remove screws in front securing infinite switch to
control panel.
5. Reverse procedure to reinstall infinite switch.
Bottom Access Panel Removal
(Select Models)
1. Grasp top of bottom access panel and gently pull
down and out.
2. Reverse procedure to reinstall bottom access panel.
Removing and Replacing Range
1. Remove power from unit.
2. Disconnect downdraft blower motor and remove flex
ducting to the blower and range (select models).
NOTE:
To avoid countertop damage, do not move
range forward until range has been raised
enough to clear all cabinetry.
3. Pull the range forward out of the cabinet opening.
4. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
5. Replace the oven using the installation instructions
and anti-tip bracket(s).
Cartridge Assembly Removal
(Select Models)
Cooktop cartridges are installed on the left side of the
range cooktop.
1. Remove power from unit.
2. Lift up on the tab (located on the cartridge) until top of
cartridge clears the opening on the range by 2 inches.
NOTE:
Lifting the cartridge too high while still engaged
in the receptacle could damage the terminal
plug.
3. Hold cartridge by the sides and slide away from
terminal receptacle.
4. Lift cartridge out when fully unplugged.
Install cartridges here
Maintop Assembly Removal
1. Remove power from unit.
2. Remove range from installation position, see
“Removing and Replacing Range” procedure.
3. Remove air grill, filter, grill grates, aeration pan and
cartridges (select models).
4. Remove screws from plenum area at front of opening.
5. Open oven door and remove screws securing
maintop to oven chassis, located on the bottom of
control panel and along the outside edges of the
maintop.
6. Remove cartridge receptacles and grill pans (select
models).