Jeep Grand Cherokee 2015, Operating Information Manual

Page: 124 / 878

Turning LaneSense ON Or OFF
The default status of LaneSense is “OFF”.
The LaneSense button is located on the switch
panel below the Uconnect® display.
To turn the LaneSense system ON, press the
LaneSense button to turn the system ON (LED
turns off). A “Lane Sense On” message is
shown in the EVIC/DID.
To turn the LaneSense system OFF, press the
LaneSense button once to turn the system OFF
(LED turns on).
NOTE:
The LaneSense system will retain the last
system state ON or OFF from the last igni-
tion cycle when the ignition is changed to
the ON/RUN position.
LaneSense Warning Message
The LaneSense system will indicate the current
lane drift condition through the Electronic Ve-
hicle Information Center (EVIC) or Driver Infor-
mation Display (DID).
3.5 EVIC Screen — If Equipped
When the LaneSense system is ON; the lane
lines are gray when both of the lane boundaries
have not been detected and the LaneSense
indicator is solid white.
LaneSense Warning Button
Lane Sense On Message
System ON (Gray Lines/White Indicator)
121