4WD LOW on dry, hard-surfaced roads may
cause increased tire wear and damage to drive-
line components.
When operating your vehicle in 4WD LOW, the
engine speed is approximately three times that
of the normal driving mode at a given road
speed. Take care not to overspeed the engine
and do not exceed 25 mph (40 km/h).
Proper operation of four-wheel drive vehicles
depends on tires of equal size, type, and cir-
cumference on each wheel. Any difference will
adversely affect shifting and cause damage to
the driveline components.
Because four-wheel drive provides improved
traction, there is a tendency to exceed safe
turning and stopping speeds. Do not go faster
than road conditions permit.
Shift Positions
For additional information on the appropriate
use of each 4WD system mode position, see
the information below:
NEUTRAL
This range disengages the driveline from the
powertrain. It is to be used for flat towing behind
another vehicle. Refer to “Recreational Towing” in
“Starting and Operating” for further information.
WARNING!
You or others could be injured or killed if you
leave the vehicle unattended with the power
transfer unit in the NEUTRAL (N) position
without first fully engaging the parking brake.
The NEUTRAL (N) position disengages both
the front and rear drive shafts from the
powertrain and will allow the vehicle to roll,
even if the transmission is in PARK. The
parking brake should always be applied
when the driver is not in the vehicle.
4WD LOW
This range is for low speed four-wheel drive. It
provides an additional gear reduction which
allows for increased torque to be delivered to
both the front and rear wheels while providing
maximum pulling power for loose, slippery road
surfaces only. Do not exceed 25 mph (40 km/h).
NOTE:
Refer to “Selec-Terrain® – If Equipped” for
further information on the various positions
and their intended usages.
Shifting Procedures
Shifting Into 4X4 LOW
With the vehicle at speeds of 0 to 3 mph (0 to
5 km/h), the ignition switch in the ON position
and the engine running, shift the transmission
into NEUTRAL, and press the “4WD LOW”
button once. The “4WD LOW” indicator light in
the instrument cluster will begin to flash and
remain on solid when the shift is complete.
Selec-Terrain Switch
269
Summary of Contents for Grand Cherokee 2015
