Chapter 2
Quick Tour
Exploring the connector panel
OneExpert DSL User’s Guide
10
22052280, Revision 001
April 2014
•
RJ45 toning
•
Wire mapping to smart remote
RJ11 Wiring connector
The RJ11 Wiring connector is used for:
•
RJ11 wire ID
•
RJ11 toning
•
Coax wire ID (with supplied adapter cable)
•
Coax toning (with supplied adapter cable)
•
RJ11 wire mapping to smart remote
•
Volt/Ohm measurements
DSL connector
The DSL connector, located on the bottom module, is used for:
•
Testing VDSL or ADSL on twisted pair cable
Rings
The rings on the corners of the instrument can be used to attach a carry strap.
WARNING: ELECTRICAL SHOCK
Electrical shock may result in serious injury or death. Use care when connecting to telecommu-
nications circuits, to be sure that you do not come in contact with exposed conductors or power
mains. Connect TNV signals to TNV ports only.
CAUTION: FIRE HAZARD
To reduce the risk of fire, use only 26 AWG or larger telecommunications line cord between the
DSL connector and the wall.
NOTE: ELECTROSTATIC DISCHARGE IMMUNITY
When using an Ethernet crossover cable, JDSU recommends using a shielded crossover cable
for the best immunity to electrostatic discharge (ESD).
Summary of Contents for OneExpert DSL
Page 1: ...OneExpert DSL User s Guide...
Page 2: ......
Page 16: ...About this Guide Conventions OneExpert DSL User s Guide xiv 22052280 Rev 000 April 2014...
Page 119: ......
