Jasic EVO 2.0 HRC-01, Operator'S Manual

Page: 13 / 20

13
A
B
C
D
A
DESCRIPTION OF THE WIRED & WIRELESS HAND REMOTE CONTROLS
Three hand held wired/wireless remote controls are available in this design, the HRC - 01 (wired 9 pin),
HRC - 02 (wireless) and the HRC - 04 Wired 3 pin) remote and can be used with the following EVO machine
models:
•
EA - 160 & EA - 200 (HRC - 04)
•
EM - 160C & EM - 200C (HRC - 01 & HRC - 02)
•
EM - 200CT & EM - 250CT (HRC - 01 & HRC - 02)
•
ET - 200 & ET - 200P (HRC - 01 & HRC - 02)
•
ET - 200P ACDC (HRC - 01 & HRC - 02)
HRC - 01 and HRC - 04 Hand held wired remote controls:
A. Current adjustment control dial
B. Remote control connection cable
•
HRC - 01 wired with 9 pin control plug
•
HRC - 04 wired with 3 pin control plug
HRC - 02 Hand held wireless remote control:
C. Wireless remote control display area
D. Wireless connection button
E. Current adjustment control dial
F. Power on and off button
FITTING OF BATTERIES FOR WIRELESS HAND REMOTE CONTROL
The remote control is fitted with qty 2 1.5 AA type battery which are designed to last approximately
250hrs based of operation actions of the remote controller.
When required, please follow the below procedure when replacing the battery.
1. Carefully using a small screwdriver remove the cover retaining screw as shown in the image below
item (A).
2. Remove the battery protective
cover (B).
3. Remove and then install the
correct sized and rated replacement
batteries as shown in image right (C).
4. Now re - install the back cover of the
remote controller.
5. The is also a belt clip attachment for the remote
which can be removed as shown above (D)
Please Note:
For further information regarding the operation/setup of remote
control, please consult your EVO machine operating manual.