16
TROUBLESHOOTING
The following operation requires sufficient professional knowledge on electric aspects and
comprehensive safety knowledge. Make sure the input cable of the machine is disconnected
from the electricity supply and wait for 5 minutes before removing any machine covers.
The above chart lists general problems that maybe experienced with a wireless remote controller
Packaging, transportation, storage and waste disposal
Transportation requirements
When handling the remote control, the device should always be handled with care, and should not be
dropped or severely impacted. Avoid moisture and rain during transportation.
Storage
Storage temperature:
-
25°C
-
+50°C
Storage humidity: Relative humidity
≤ 90%
Storage period: 12 months
Storage site: Indoors with no corrosive gas and air circulation
Waste disposal
The equipment is manufactured with materials, which do not contain any toxic or poisonous materials
dangerous to the operator.
When the equipment is scrapped, it should be dismantled separating components according to the type
of materials.
Do not dispose of the equipment with normal waste. The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment states the electrical equipment that has reached its end of life must
be collected separately and returned to an environmentally compatible recycling facility.
In order to comply with WEEE regulations in your country you should contact your supplier.
RoHS Compliance Declaration
We herewith confirm, that the above mentioned product does not contain any of the restricted
substances as listed in EU Directive 2011/65/EC in concentrations above the limits as specified therein.
Disclaimer: Please note that this confirmation is given to the best of our present knowledge and belief.
Nothing herein represents and/or may be interpreted as warranty within the meaning of the applicable
warranty law.
Symptoms
Reason
Troubleshooting
The wireless
remote controller
cannot adjust the
welding current
Wireless remote control
not connected
Reconnect wireless mode from the welding
machine to the remote control device.
Reboot the welding machine.
The wireless remote
controller batteries are
out of power
Replace the remote controllers batteries.
Using the remote from
too great a distance
or there are too many
obstacles in the way
Reposition the EVE welding machine closer to
the welding job and try again.
Remove any obstacles that maybe in the way
Other malfunctions
Check the connection of the receiver module
to the main control PCB.
Possible fault with controller of receiver module,
try replacing either one of the items.
Summary of Contents for EVO 2.0 HRC-01
Page 1: ...1 Wired and Wireless Remote Control...
Page 20: ...20...