Jasic EVO 2.0 HRC-01, Operator'S Manual

Page: 14 / 20

14
OPERATION OF THE WIRELESS HAND REMOTE CONTROL
Wireless connection
Depending on the model and user interface of your EVO model the below instructions may differ, please
refer to your EVO product operating manual for further instructions.
Powering up your wireless controller
To power up your hand remote controller, press the power button of the controller and the power
indicator will then turn on.
To turn off your hand remote, press and hold the power button and the device will be powered off.
Pairing up your wireless controller
Model dependent and following powering up the machine up but before welding, activate the wireless
connection option and blue indicator on the receiver module will flash.
At the same time, press the wireless "Connect" button of the wireless remote controller and after the
EVO machine control panel displays "OK" and the blue indicator will remain
‘ ON ’ this indicates that the
wireless connection is successful and the remote and machine have paired up.
Current/parameter adjustment operation
Following successful pairing of your wireless connection, press the power button of the remote controller,
and by rotating the knob to adjust the welder current and display the value on the LCD screen on the
wireless handheld remote controller in real time; after completing the parameter adjustment you can
press the power button of the remote controller to enter lock mode which deactivates the controls so
to avoid mis
- operation.
For normal use of the remote controller, ensure you have enabled the remote function via the control
panel of EVO machine.
If the remote controller is not operated for a period of time, it will enter into standby mode and then
powers down after 10s and 10 min, respectively.
When the battery of the wireless hand controller is low, the indicator will flash.
PLEASE NOTE:
•
After successfully connecting the wireless remote controller, do not press and hold the wireless
"Connect" button again during normal use; otherwise, it will disconnect itself from the welding
machine. To reconnect the remote device, you would need to repeat the above steps of wireless
connection!
•
Please operate the wireless remote controller at a distance of more than 1m from the ground,
otherwise, the transmission distance will be affected!
•
For further information regarding the operation/setup of remote control, please consult your EVO
machine operating manual.
Remote Model Suitable machine Remote Control Function Range
HRC - 02
EM - 160C / EM - 200C
EM - 200CT / EM250CT
On MIG non - synergic mode: Adjusts wire feed
speed and welding voltage.
On MIG synergic mode: Adjusts welding
current, and welding voltage.
On Lift TIG mode: Adjusts welding current.
30m
ET - 200 / ET - 200P
ET - 200P ACDC
DC TIG: Adjusts welding current.
DC pulse TIG: Adjusts welding current and
pulse frequency.
AC (pulse) TIG: Adjusts welding current and AC
balance.