Jasic EVO 2.0 HRC-01, Operator'S Manual

Page: 11 / 20

11
INSTALLATION OF WIRELESS REMOTE CONTROL RECIEVER MODULE
The below operation requires sufficient professional comprehensive knowledge of electrical
circuits and electrical safety. Make sure the input cable of the machine is disconnected from
the electricity supply and wait for 5 minutes before removing the machine covers.
Installation of wireless receiver module
The HRC - 01, HRC - 02 and HRC - 04 remote control unit can be used with the
following EVO machine models:
EA - 160 & EA - 200 (HRC - 04)
EM - 160C & EM - 200C (HRC - 01 & HRC - 02)
EM - 200CT & EM - 250CT (HRC - 01 & HRC - 02)
ET - 200 & ET - 200P (HRC - 01 & HRC - 02)
ET - 200P ACDC (HRC - 01 & HRC - 02)
Wireless hand - held remote - control connection
An option with the EVO range of machines is for the
operator to be able to wirelessly control the welding current.
To enable this then you will require to fit the optional remote interface module.
1) Ensure machine is unplugged from the machines supply
2) Leave the machine at least 5 minutes before removing any covers
3) Remove the screws on the left cover of the machine.
4) Carefully place the panel to one side
5) You now have access to the inside front area of the machine
Installation of the wireless receiver module
1) Remove the plastic cap ‘ A ’ shown in the image right and fit the wireless
receiver module as shown.
2) If you haven ’ t already, remove the screws of the left side cover of the
machine as described above.
3) Remove the buckle from inside the front panel of the machine and pull out
the plug (A).
4) The wire receiver (as shown below) C will fit into the machine by first feeding the
cable connector and cable through the front panel hole where you removed
the plastic cap (A)
5) Now insert the receiver module ‘ B ’ to the front panel (notches up), and then
clip the module in place
PLEASE NOTE:
Please check that your machine supports wireless hand held or foot remote controls before installation.
C