Jasic EVO 2.0 HRC-01, Operator'S Manual

Page: 15 / 20

15
OPERATION OF THE WIRED HAND REMOTE CONTROL
Wired connection
Depending on the model and user interface of your EVO model the below instructions may differ, please
refer to your EVO product operating manual for further instructions.
Connecting your wired controller
Model dependent and prior to powering up your EVO
machine, when fitting either the 3 or 9 pin remote
plug, ensure you align the keyway when inserting the
plug, then rotate the threaded collar fully clockwise
until finger tight and shown right.
HRC - 01 (9 pin connector)
HRC - 04 (3 pin connector)
Current/parameter adjustment operation
After successfully inserting the connector plug of the wired handheld remote control to the machine,
power up your EVO machine and then enable the remote control function of the machine.
The wired handheld remote control can then be used for adjusting welding current in MMA and Lift TIG
welding modes.
Please Note:
For further information regarding the operation/setup of remote control, please consult your EVO
machine operating manual.
Remote Model Suitable machine Remote Control Function Range
HRC - 01
(9 pin connector)
EM - 160C / EM - 200C
EM - 200CT / EM250CT
ET - 200 / ET - 200P
ET - 200P ACDC
Adjust welding current on MMA mode only
15m
5m fitted as
standard
HRC - 04
(3 pin connector)
EA - 160 / EA - 200
Adjust welding current on MMA
mode and Lift - TIG mode