4-1
Section
4
Setup
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
Section 4 Setup
This section describes the procedure for connecting peripheral devices and BDE, BOW correction
value adjustments, and external input settings of GYRO and GPS.
4.1 Connecting devices and power on
4.1.1 Connecting devices and BDE
Connect the setup PC and MGMT LAN with Ethernet cable.
Note
If NSD is connected to the MGMT LAN, temporarily disconnect the connection.
Set the IP address of the PC. Under the factory default settings, JUE-60GX is set as follows.
BDE IP address
192.168.1.2
ADE IP address
192.168.1.3
ADE/BDE subnet mask
255.255.255.0
Here, as an example, the IP address of PC is set as follows.
IP address
192.168.1.100
Subnet mask
255.255.255.0
JUE-60GX BDE Rear view
Setup PC
Summary of Contents for JUE-60GX
