Japan Radio Co. JUE-60GX, Instruction Manual

Page: 122 / 150

Appendix E Troubleshooting & FAQ E-2
Problem Probable cause Confirmation item
ANT LED blinked in red. The antenna points to
the direction of
transmission-prohibited
area. Confirm the antenna pointing direction
through the Web interface.
If the antenna points to the
transmission-prohibited area, wait until the
ship moves and the antenna pointing
direction is outside the
transmission-prohibited area.
The antenna points to
the blocking area
direction. Confirm the antenna pointing direction
through the Web interface.
If the antenna points to the blocking area,
wait until the ship moves and a shield
disappears between the antenna and the
satellite.
STS1 LED lighted in red. In BIM, an alarm is
detected. Refer to “Appendix E.4. Corrective action
when alarm occurs.”
STS2 LED lighted in red. In AIM, an alarm is
detected.
STS3 LED lighted in red. In CM, an alarm is
detected.
STS4 LED lighted in red. In BUC, an alarm is
detected.
BDE is not powered off.
READY LED continues to
blink in red. BDE is in process of
termination. BDE termination process takes about 20
seconds on average.
However, BDE is not powered off even after
one minute has elapsed, confirm that the
BDE power switch is off, and extract and
insert the power cable.
The power was turned
on during BDE
termination process. Turn off the power again, and wait for a
while.
BDE termination process takes about 20
seconds on average to up to one (1)
minute.
Note
The motor driving noise from ADE is not trouble. The mechanical trouble of ADE is
confirmable by "E.4 Corrective action when alarm occurs".