janitza UMG 605 PRO, User Manual And Technical Data

Page: 52 / 87

UMG 605-PRO
www.janitza.de
47
12. System information
12. 1 Measurement range exceeded
If the measurement range is exceeded,
it is displayed as long as this persists and
cannot be acknowledged. The measurement
range is exceeded if at least one of the
four voltage or current measurement inputs
is outside its specified metering range.
If the measurement range is exceeded,
this is shown on the display with “EEEE”.
Symbols L1, L2, L3 and L4 are used to show
the input on which the measurement range
was exceeded. The "V" and "A" symbols
indicate whether the measurement range
has been exceeded in the current or voltage
circuit.
Fig. Measured value indication for the firmware release.
RxD TxD L1 L2 L3 L4 Input Output
12. 2 Firmware release
Fig. Measured value indication with time.
RxD TxD L1 L2 L3 L4 Input Output
12. 3 Time
L1 L2 L3 L4
RxD TxD
VA
L1 L2 L3 L4 Input Output
Fig. Measured value indication with measurement range
exceeded.
Fig. Measured value indication with serial number.
RxD TxD L1 L2 L3 L4 Input Output
12. 4 Serial number
Fig. Measured value indication with date.
RxD TxD L1 L2 L3 L4 Input Output
12. 5 Date
m
CAUTION!
Damage to property
due to not observing
the connection conditions
Failure to observe the connection conditions
can damage or destroy your device.
Therefore, note the following:
• Adhere to the specifications for voltage
and frequency on the rating plate.