www.janitza.de
19
Module 96-PA-RCM / 96-PA-RCM-EL
Fig. basic device
Module connector
socket
Module-connector plug
(rear of module)
Fig.
Module 96-PA-RCM-EL
(with Ethernet interface)
CAUTION
Disregard of the installation instructions may
cause property damage or personal injury!
Non-observance of the assembly instructions may
cause damage to your basic device with module or
destroy it and/or may also result in personal injury.
·
Observe the assembly instructions of your
basic device.
·
Disconnect your basic device from the pow-
er supply prior mounting the module!
·
Provide adequate air circulation in your
installation environment and cooling, as
needed, when the ambient temperatures are
high.
·
Before mounting, remove the transport pro-
tection from the module connector plug of
the module and the protection from the mod-
ule connector socket of the basic device.
Mounting module:
1. Disconnect the system (basic device) from the
power supply!
2. Remove the transport protection from the
module connector plug of the module and the
protection from the module connector socket
of the basic device.
3. Slide the module into the slot on the rear side
of the basic device and use slight pressure to
press it into the basic device until the module
connector audibly snaps in.
4. Connect the system (basic device) to the
power supply. The basic device recognizes
the plugged in module automatically.
4.2 Module mounting
INFORMATION
The basic device supports the module functions
only if the module is detected during the startup
process (e.g. residual current or DC power)! If
there is no communication with the module:
·Disconnect your system (the basic device) from
the power supply and check the positioning of
the RCM module. Carefully press the module
onto the basic device until it audibly snaps into
place.
·If necessary, restart the basic device (section
„8.3 Restarting the basic device“ on page 40)!
·If these measures are unsuccessful, please con-
tact our support team (www.janitza.de)!
