37
www.janitza.de
800-DI14 module
12. Dismounting
ATTENTION
Material damage due to disassembly or decou-
pling of the module during operation!
Dismounting or decoupling the module during com-
munication with the basic device can cause damage
to your devices!
·
Disconnect your system from the power supply
prior to dismounting or disconnecting the
module! Secure it against being switched back
on! Check to be sure it is de-energized! Ground
and short circuit! Cover or block off adjacent
live parts!
ATTENTION
Handling your module too roughly may cause
damage to the module and result in material
damage!
The bus connector contacts and the bottom bolts can
be damaged or broken off when dismounting your
module.
·
Never pull the module out of the DIN rail force-
fully.
·
First decouple the bus connectors (JanBus
interface) and carefully unlock the bottom bolts
of the module with a screwdriver!
1. Disconnect the supply of power to the system!
Secure it against being switched on! Check to be
sure it is de-energized! Ground and short circuit!
Cover or block off adjacent live parts!
2. Disconnect the wiring of your module.
3. Decouple the bus connectors (JanBus interface)
of your module from the basic device and/or the
connected modules by pulling out your module.
4. Unlock all bottom bolts of your module.
Recommendation:
Use a screwdriver for this
(be careful!).
5. Remove your module from the DIN rail without
touching or damaging the bus connector con-
tacts.
INFORMATION
After dismounting the 800-DI14 module, the Grid-
Vis
®
software deactivates the corresponding mod-
ule!
Information on this and further procedures can be
found in the online help for the GridVis
®
software.
Bottom bolt
JanBus interface
for further modules
JanBus
Interface
Bus connector
Contacts
Bus connector
Sockets
DIN rail
Bus connector
Sockets
Bottom bolt
Fig. Dismounting the 800-DI14 module
Screwdriver for
unlocking
