Equipment Description
2-2
WMX SERIES DIMMER
OPERATING
MANUAL
3.
UP/DOWN SELECT BUTTONS:
These buttons select the DMX start channel and
various test functions.
4.
EXIT AND MENU/CONFIRM BUTTONS:
These buttons are used to navigate
through the test menu levels and set DMX address.
5.
3-DIGIT DISPLAY:
Indicates currently selected DMX start channel and various
test function options.
6.
DMX LED:
A green LED indicates the presence of DMX signals when in DMX
mode. If there is no DMX signal, the LED will flash at a rate of approximately 2
seconds on - 2 seconds off.
7.
FAULT LED:
A red LED flashes in the presence of a fault. In normal operation this
LED should be off.
8.
PHASE LEDs:
Three blue LEDs (one for each phase) indicate that the three phase
mains supply is available.
9.
DMX IN SOCKET:
Standard 5-pin AXR connector accepts DMX-512 signals from
controller.
10.
DMX LOOP SOCKET:
Standard 5-pin AXR connector links the DMX-512 signals
to other dimmers or devices.
11.
TERMINATE SWITCH:
In the right hand Loop position it links the male IN
socket to the female LOOP socket, continuing the DMX signal to other devices. The
left hand Terminate position is used to terminate the DMX signal if this unit is the
last device in DMX chain.
12.
CABLE ENTRY:
Removal of the hole plug provides access for a 32mm cable
gland. This cover should remain in place for safety reasons unless using the hole for
cable access.
13.
AIR INTAKE:
This is the main entry point for air cooling of the dimmer.
DO NOT
obstruct this entry and keep it free of dust.
Summary of Contents for WMX
Page 1: ...WMX...
