Dimmer Operation
4-3
WMX SERIES DIMMER
OPERATING
MANUAL
The “+” and “
−
” buttons are used to select a different level in 20% increments, ie. 20,
40, 60, 80, FL (100). Refer to table 4.2 for the display output in each state.
Output
Level
Phase A
Display
Phase B
Display
Phase C
Display
ALL Phases
Display
0%
20%
40%
60%
80%
100%
Table 4.2: Display Data To Output Level Relationship
The output is live and there is no need to press “Menu/
”. The display (and output)
remains in its current state until the “Exit/C” button is pressed, even if power is
disconnected. ie. when power is restored the dimmer will continue to drive the selected
phase to the same level.
When “Exit/C” is pressed, the dimmer returns to the menu displaying flashing
A, B,
C
or
ALL
. If no button is pressed within 3 seconds the dimmer returns to normal
operation, displaying the previously set DMX start channel.
4.1.2.3 CHS
Pressing “Menu/
” while
CHS
is displayed moves into the Chase menu, where the
display shows the last chase speed selected (
SP1
…
SP4
) and the chaser is immediately
turned on. Each channel from 1 to 12 is sequentially driven to full output and then the
chase sequence keeps repeating.
The “+” or “
−
” buttons are used to select a chase speed; SP1 is slowest and SP4 is
fastest. The display (and output) remains in its current state until the “Exit/C” button is
pressed, even if power is disconnected. ie when power is restored the dimmer will
continue to run the chase at the selected rate.
When “Exit/C” is pressed, the dimmer returns to the menu displaying flashing
CHS
. If
no button is pressed within 3 seconds the dimmer returns to normal operation,
displaying the previously set DMX start channel.
Summary of Contents for WMX
Page 1: ...WMX...