Installation
6-10
WMX SERIES DIMMER
OPERATING
MANUAL
6.6 Mounting the dimmer to the bracket
Dimmers are attached to the pre-mounted brackets as follows:
1. Remove the dimmer’s two front panels (sixteen screws).
2. Hang the top edge of the dimmer on the two bracket tabs. These support the weight
of the dimmer while allowing the bottom of the dimmer to pivot away from the
bracket.
3. Feed any cables (mains supply, output or control) into the rear of the dimmer and
terminate them as necessary. This may only be performed by a licensed electrician.
4. Latch the dimmer onto the bracket by lifting the dimmer a few millimetres and
allowing the bottom two bracket tabs to engage.
5. Lock the dimmer in place with one M4 screw at the bottom right inside corner.
6. Re-attach the front panels.
Figure 6.6: Attaching A Wall Mount Dimmer To The Bracket
1
2
3
4
5
6
Summary of Contents for WMX
Page 1: ...WMX...
