Charging Printer Batteries
The battery discharges when not used for a long period of time. Recharge
the battery immediately after purchase or after long periods of storage or
inactivity.
Step 1 Turn off power switch.
Step 2 Plug the DC connector into the back of the Printer then, the AC
Adapter into an AC outlet.
Step 3 Allow the battery to charge 10 hours. DO NOT charge continu-
ously for more than 24 hours.
Step 4 When finished charging, unplug the AC Adapter then the DC
connector from the Printer.
Loading Printer Paper
Step 1 Using your thumb, pull the paper holder toward the back of the
Printer (Fig. A.1).
Step 2 Lift the cover upwards.
Step 3 Turn power switch ON.
Step 4 Cut or fold the paper into an inverted "V" (Fig. A.2).
Step 5 Place the paper roll onto the inside of the cover.
Step 6 Push the top of the paper into the inlet and feed it by hand un-
til you can see the top of the paper from the paper cutter.
Step 7 Press and hold the paper feed button until the paper feeds
straight and smoothly. When the paper is correctly set, the Off
Line lamp stops flashing and stays lit.
NOTE: Red lines appear on both edges of the paper when the roll is about
to run out. Use only Jujo Paper Co. paper, part number TP411-28CL.
A-5
Appendix
Figure A.1
Figure A.2
Summary of Contents for RAC-100
