RAC-100 and 200 User’s Manual
Step 3 [CodE 0] will be displayed. At this point you are able to re-
call a specific code number, either all memory locations that
have just a specific code (i.e. code #50) or all memory locations
regardless of the code number. To view all memory locations,
press ENTER. To view only the memory locations that have a
specific code number, key in that code number and press the
ENTER key.
Step 4 The data for memory location #0 (code number and distance)
will be shown. Of course, if you only requested to see a spe-
cific code number (i.e. #45 for 45 mph speed signs), the first
memory location with that code will be selected. Using the
ADD and SUB keys, you are now able to step forward or back-
ward through the memory locations. Remember that if you
selected to see only a specific code, as you step forward or
backward through the memory you will see only the locations
with that specific code number, such as all the locations with
45 mph speed signs.
Step 5 To see the SPEED and elapsed TIME associated with each
event, press the T-S key. SPEED will be shown on the two far
left digits, elapsed TIME (hours. minutes.seconds) will be
shown on the remaining six digits. To go back to viewing the
code and distance, press the T-S key again. If, while viewing
the memory, you forget what memory location you are view-
ing, press and hold the ENTER key. The display will show you
the current memory location being displayed.
Step 6 To exit Memory View, press the VIEW key.
4-10
Summary of Contents for RAC-100
