![background image](http://html1.mh-extra.com/html/jai/rmc-673/rmc-673_user-manual_631421016.webp)
RMC-675/RMC-673
16
Hardware Installation
Figure 3.
Back Focus Set-Screw Locations
2.2.5
Auto-Iris Lens Setup
Auto-iris lenses with full video input can be used with the JAI, Inc. RM-675/RM-673.
Note: Make sure that the power is removed from the camera before connecting or disconnecting the auto-iris
lens. There is a small chance that damage could occur to the auto-iris lens by plugging or unplugging it
while the camera is powered up.
Power down the camera before installing the auto-iris lens. To install the auto-iris lens in a JAI, Inc. camera, wire
the signal on the lens into the 1 V peak-to-peak video output (pin 11) on the camera. 12 volts DC is available on
pin 3.
Point the camera at a light area and then quickly towards a darker area. If everything is working properly, the iris
should adjust for the light change.
2.2.6
Monitor Display Mode
For monitoring real time video, connect the video output to a PAL video monitor or other device.
2.2.7
Connectors and Cables
15-pin connector and cable: Standard cable is 15P-02-9P and 15P-02-9P-FULL.
Figure 4.
15P-02-9P Cable
Summary of Contents for RMC-673
Page 2: ......
Page 13: ...Hardware Introduction 13 RMC 675 RMC 673 Figure 1 RMC 675 RMC 673 System Configuration...
Page 81: ......