2-13
1. Lay the Mount Arm flat on work surface.
2. Using the large T-Wrench remove the two Clamp
Screws and the Arm Clamp from the 4 inch Mount
Arm.
3. Rotate the 3 inch Arm and position the 4 inch
Mount Arm onto the Joint Pin as shown. Replace
the Arm Clamp and the two Clamp Screws. Tighten
the Clamp Screws.
Note:
The Clamp Screws on the 3 inch Arm and
the 4 inch Mount Arm should be facing opposite
directions as shown in photo.
Rotating Mount Arms
Summary of Contents for WREX
