Optional Side Attachment
2-8
1.
Using the large T-Wrench l
oosen,
Do not remove,
the two
T-Nut Screws on the Mount Adapter.
2. Insert the T-Nut into Keyed Back Post channel and position the
MR-8 Mount Adapter at the marked location (see Preparing
Mount Base #1). Tighten the two T-Nut screws.
3.
Orient the Arm Mount Base as shown in illustration.
Insert the Mount Base Screw (supplied with
Arm Mount Base) thru the Attachment Hole to
the MR-8 Mount Adapter. Using the large T-Wrench
secure these two parts.
Note:
Adjustments in position may be necessary for
optimal function.
4. Loosen but
do not remove
the Locking Knob
on the Arm Mount Base.
5. Position the Mount Link so that the Alignment Pin in
the Arm Mount Shaft is aligned with the Alignment
Slot of the Arm Mount Base. Insert the shaft into the
base and tighten the Locking Knob.
Summary of Contents for WREX
