7. Snug but do not tighten the
six
Clamp Screws
using the large T-Wrench.
Add enough
tension so that the joints do not move easily
but can be repositioned if required to optimize
the arm alignment.
Note:
Do not tighten the Clamp Locking Set
Screws at this time.
8. Hold the Pitch Mount Shaft so that the black
Pitch Pivot is at the proximal end, the hole
through the Pitch Pivot is in the line of
progression of the chair and the plate of the
pivot is facing laterally. Insert the Pitch
Mount Shaft into the Shaft Mount Base. Snug
but do not tighten the Shaft Screws on the
Shaft Mount Base.
9. With client sitting in the chair align the
square hole in the Pitch Pivot approximately
1 ½ inches above their shoulder.
2-5
Summary of Contents for WREX
