Page 85
J-400
!
DANGER:
TURN THE SPA BREAKER TO THE OFF
POSITION!
!
WARNING
:
DRAIN THE SPA IF YOU ARE REPLACING OR
CLEANING THE QUARTZ TUBE!
!
WARNING:
ALLOW BULB TO COOL DOWN PRIOR TO
REMOVING FROM QUARTZ TUBE.
!
DANGER:
NEVER LOOK AT THE LIT BULB. THIS CAN
CAUSE SEVERE EYE DAMAGE OR BLINDNESS.
UV bulb replacement and quartz tube maintenance:
Note
:
Location of CLEAR
RAY
System and connection may vary by
model.
1. Turn the breaker to the spa OFF. DRAIN YOUR SPA.
Disconnect the CLEAR
RAY
System from the
controller, Figure 2.
Note:
If you are only replacing the UV bulb then the spa
does not have to be drained. You will need to drain it if
you are replacing or cleaning the quartz tube.
2. Once the UV bulb has cooled off remove the CLEAR
RAY
System
enclosure cover (10) and gasket (9) by removing the four screws
(11).
3. Remove the black bulb boot (8) by sliding it over the cable away from
the quartz seal compression nut (7), Figure 3.
4. Slowly remove the UV bulb (4) out of the quartz tube.
5. Remove bulb socket (5) from the UV bulb (4), Figure 4.
6. Remove the quartz seal compression nut (7) by turning it
counterclockwise,
Figure 3. Use a pair of
channel-lock pliers if needed, Figure 5. You will
notice that there is a stainless steel compression
washer (6) that slides over the quartz tube. Save
the washer (6) for later use, Figure 6. There is
also a black seal ring (13), grasp the black seal
ring; slowly and carefully remove the quartz tube.
WARNING!
DONOT LOOK AT LIT BULB
SEVERE EYE DAMAGE
OR BLINDNESS CAN OCCUR
Figure 2
UV
Unit
Connection
DANGER:
NEVER REMOVE COVER WITHOUT FIRST
TURNING OFF AT POWER SOURCE AND DRAINING THE
SPA.
!
Figure 4
7
4
8
Figure 3
4
5
Figure 5
6
13
7
2
Figure 6
