Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a
list of automated functions performed by your spa. These functions are listed
below in an attempt to suppress any operational concerns you may have during
the first 24 hours of ownership! Also listed below are important maintenance
recommendations you should observe on a regular basis to protect your new
investment.
Automated Spa Operations
Your new spa is equipped with an automated “clean-up” cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00
PM (noon), each pump will activate and run for one minute. If either pump
has just finished a 20 minute time out, it will not automatically activate for the
clean-up cycle. Be aware, the factory programmed clean-up cycle cannot be
canceled or altered!
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters:
With
CLEAR
RAY
®
Without
CLEAR
RAY
®
pH
7.4-7.6
7.4-7.6
Free chlorine
no less than 1.0 ppm 3.0-4.0 ppm
Free bromine
no less than 2.0 ppm 2.0-4.0 ppm
Total Alkalinity
100-120 ppm
100-120 ppm
Calcium Hardness 150-250 ppm
150-250 ppm
IMPORTANT:
CLEAR
RAY
® Water Purification System is factory installed. If
the CLEAR
RAY
® system is altered or is not operating efficiently then follow
the “without CLEAR
RAY
®” water chemistry parameters as defined by the
Association of Pool and Spa Professionals. CLEAR
RAY
® requires an annual
bulb replacement to properly sanitize your water.
!
TO DECREASE RISK OF INFECTION OR DISEASE!
Always maintain
your spa filter as outlined below to ensure healthy spa water. Refer to pages
74-77 (Sec. 15.0) for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that
provides unsurpassed water quality! To ensure maximum water quality at all
times, you should clean the skimming filter cartridge every three months, or as
necessary. See pages 74-77 (Sec. 15.0) for detailed filter cartridge cleaning
instructions.
Required Water Replacement
!
TO DECREASE RISK OF INFECTION OR DISEASE!
You should
replace the spa’s water every 3 months. The frequency depends on a number
of variables including frequency of use, number of users and attention paid to
water quality maintenance. You will know it is time for a change when you cannot
control sudsing and/or you can no longer get the normal feel or sparkle to the
water, even though the key water balance measurements are all within the proper
parameters. See pages 82-84 (Sec. 16.0) for additional information.
©Jacuzzi Hot Tubs, Inc. All Rights Reserved
