Jacuzzi J - 375, Owner'S Manual

Page: 2 / 80

Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a
list of automated functions performed by your spa. These functions are listed
below in an attempt to alleviate any operational concerns you may have during
the first 24 hours of ownership! Also listed below are important maintenance
recommendations you should observe on a regular basis to protect your new
investment.
Automated Operations
Your new spa is equipped with an automated “clean-up” cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00
PM (noon), each pump will activate and run for one minute. If either pump
has just finished a 20 minute time out, it will not automatically activate for the
clean-up cycle.
Note: Turning off the corresponding jets pump that is running can deactivate the
feature.
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters:
With CLEAR RAY® Without CLEAR RAY®
pH 7.4-7.6 7.4-7.6
Free Chlorine no less than 1.0 ppm 3.0-4.0 ppm
Free Bromine no less than 2.0 ppm 2.0-4.0 ppm
Total Alkalinity 100-150 ppm 100-150 ppm
Calcium Hardness 150-250 ppm 150-250 ppm
IMPORTANT: CLEAR RAY ® Water Purification System is factory installed. If
the CLEAR RAY ® system is altered or is not operating efficiently then follow the
“without CLEAR RAY ®” water chemistry parameters as defined by the Asso-
ciation of Pool and Spa Professionals. CLEAR
RAY
® requires an annual bulb
replacement to properly sanitize your water.
!
TO DECREASE RISK OF INFECTION OR DISEASE! Always maintain
your spas filter as outlined below to ensure healthy spa water. Refer page 46
“Water Quality Maintenance” for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides
unsurpassed water quality! To ensure maximum water quality at all times, you
should clean both filter cartridges every month, or earlier as necessary. See page
39 for detailed filter cartridge cleaning/replacement instructions.
Required Water Replacement
!
TO DECREASE RISK OF INFECTION OR DISEASE!
You should replace
the spa’s water every 3 months. The frequency depends on a number of variables
including frequency of use, number of users, and attention paid to water quality
maintenance. You will know it is time for a change when you cannot control
sudsing and/or you can no longer get the normal feel or sparkle to the water,
even though the key water balance measurements are all within the proper
parameters. See page 46 for additional information.
**Specifications and operations subject to change without notice.**