J-200
CAUTION:
Never spray cabinet with a garden hose for any
reason since this action may induce an electrical short in the
spa’s electrical equipment.
12.7 Winterizing
Your Jacuzzi spa is designed to automatically protect itself against
freezing when operating properly. During periods of severe freezing
temperatures, you should check periodically to be certain that the
electrical supply to the spa has not been interrupted. In extreme, bitter
cold weather less than -20°F (-29°C), choose the F3 “Standard” filtration/
heating mode to prevent freezing (page 29). If you do not intend to
use your spa, or if there is a prolonged power outage during periods
of severe freezing temperatures,
it is important that all water be
removed from the spa and equipment to protect against damage
from freezing.
Expert winterization of your spa is highly recommended, contact
your authorized Jacuzzi dealer.
In emergency situations, damage can
be
minimized
by taking the following steps:
CAUTION: TURN OFF POWER TO HOT TUB!
Follow the directions on page 36 for draining the spa.
1. Turn off power to the spa.
2. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and
into the footwell, such as a wet/dry vacuum.
3. Turn the massage/diverter selector(s) into the middle combo position
to allow the water in the plumbing lines to drain, see page 27.
4. Turn the waterfall valve to the open position to allow the water in the
plumbing lines to drain, see page 23 and 24.
5. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and
into the footwell, such as a wet/dry vacuum.
6. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
7. Remove the synthetic cabinet panel under the control panel and
locate the drain plugs on the front of the pump(s), (Figure A, page
15). Remove plugs to allow water to drain out of pumps and
heater.
Note:
Approximately one to two gallons will be released during this
procedure. Use a wet/dry vacuum or other means to keep this from
flooding the equipment compartment. Replace the drain plugs.
8. Loosen hose clamp at bottom of CLEAR
RAY
® system and pull hose
off of CLEAR
RAY
fitting (twist the hose back and forth while pulling
downward). Tip hose down and allow to drain. Then reinstall hose
and clamp. Remove the cover of the CLEAR
RAY
system to access
the UV bulb and quartz tube. Remove and store the UV bulb in a
38
