144
Replacement of differential oil
Screw off the drain hole plug (D) in the bottom of the rear axle case to drain the
gear oil in it, infill the specified gear oil into the rear axle case through the level
inspection hole, until the oil level goes up to the screw plug (L)of the level in
鄄
spection hole.
Replacement of the greases for the front and rear hub bearings
Replacement of the greases for the front and left hub bearings needs disas
鄄
sembly and reassembly of the bearings, so please entrust the authorized JAC
service stations to do that. Proper maintenance and driving can prolong the ve
鄄
hicle service life, but also can improve the fuel and oil economic efficiency.
OWNER
爷
S MANUAL
JAC High end Light Trucks
Replacement of steering oil and fluid
Exhaust fluid
1. Jack up the front axle off the ground completely.
2. Remove the oil pipes (2 pieces) between the steering gear and the power
steering oil reservoir.
3. After the steering fluid is drained off, start the engine in short time, turn the
steering wheel right and left to its limit positions without over 15 seconds, until
the residual fluid is completely drained from the steering pipes.
New fluid fill-up
1. Fix the removed oil pipe in the oil pot and infill the specified power steering
fluid.
2. Fill in the power steering fluid up between the scale marks in the oil pot.
Take care that the fluid surface sinks in parallel with the fill-up, so as to keep a
stable level against any air trapped in.
3. Lower down the front wheels onto the ground, start the engine into idle
speed for several minutes, and rotate the steering wheel right and left.
4. Check the level against the scale mark, and add some more if needed.
145
Summary of Contents for HFC1035KD
Page 5: ...5 Information about new vehicles...
Page 9: ...Controller and instrument 13...
Page 24: ...CD and Radio 43...
Page 53: ...Repair and maintenance 101...
