92
Wiring connection steps
Jumper cables can be used to connect the battery in another truck to start the
engine in the truck that has trouble.
1. Use a truck that is provided with a battery of the same rated voltage (12V).
2. Connect the jumper cable in the following steps.
淤
positive terminal of the totally discharged battery
于
positive terminal of the auxiliary battery
盂
negative terminal of the auxiliary battery
榆
The chassis grounding wire with the totally discharged battery, the grounding
wire be away from the totally discharged battery as far as possible.
3. After the jumper cable is connected, start the engine in the truck that has
auxiliary battery.
4. Increase the speed of the engine in the truck that has auxiliary battery, and
then start the engine in the truck whose battery is totally discharged.
5. After the engine gets started, disconnect the jumper cable in the reverse order.
Never connect the cable between the positive and negative terminals. Do not disconnect the cable from the terminal pillar
while the engine is still running, otherwise a failure will occur in the electrical system.
OWNER
爷
S MANUAL
JAC High end Light Trucks
Traction
Pay attention to the following points when tracking vehicles:
1. If the gearbox can work normally, its gearshift lever should be placed in neu
鄄
tral.
2. If any failure occurs to the transmission, it will be necessary to dismantle the
propeller shaft from the flange on the rear axle and have its end tightened to
the frame.
Then, put the traction cable (safety chain or cable) onto the hooks of the track
鄄
ing truck and the vehicle that cannot run. Traction shall be done at a speed of
40km/h or below.
93
Summary of Contents for HFC1035KD
Page 5: ...5 Information about new vehicles...
Page 9: ...Controller and instrument 13...
Page 24: ...CD and Radio 43...
Page 53: ...Repair and maintenance 101...