JABLOTRON
ALARMS
a.s.
Pod
Skalkou
4567/33
46601
Jablonec
n.
Nisou
Czech
Republic
www
.jablotron.com
||
|
JA-14K(R) Security System Control Panel
25 / 72
MNX22101
b.
By connecting the battery to a wireless device
- however, at least one radio module must be
enrolled first. Remote controls of the JA-16J type are enrolled by pressing of both upper
buttons.
c.
By entering the serial number in the SN production code field
(it is found under the barcode
on the board inside the device, e,g. 1400-00-0000-0123). The number can also be read with an
optical barcode reader. Subsequently, you should activate the detector to verify its enrollment.
d.
By selectively loading not enrolled BUS devices
– if one or more devices that have not been
enrolled yet are connected to the BUS, after pressing of
Enroll
in the
Device
the
Scan/add
new BUS devices
button will be displayed, which will offer enrollment of the BUS device. You
will enroll the device by double clicking on the selected item.
e. By collectively loading
not enrolled BUS devices
– if one or more devices that have not been
enrolled yet are connected to the BUS, after pressing of the
Scan/add new BUS devices
button all the BUS devices will be enrolled collectively. This procedure does not allow you to
determine the sequential positions for individual devices.
3. You can delete a device by deleting its production code (just the entire device will be deleted) or by
selecting the respective line in the Devices tab and the Delete option in the menu or under the right
mouse button or by merely pressing the Delete key, which will delete the whole line of the device (with
its settings of the section, reaction, PG output control, notes and other options). This way, after marking
more devices (click+Shift or click+Ctrl) you can delete all of them or you can just change a common
parameter.
Caution:
It is recommended to enroll wireless devices to the system according to point B in real conditions and at the
required place in the protected premises. You can prevent troubles with insufficient RF range when you enroll
devices “on the table”.
Notes:
−
BUS devices that have not been enrolled flash with yellow light. If a not enrolled device does not start
flashing with the yellow LED within approx. 180 s after enabling of the power supply of the control panel
(in the course of initialization) check whether the device is properly connected.
−
Wireless devices with unidirectional communication do not have any means of signalling the enrollment
request.
−
If you enroll a device in the system using the above mentioned procedure, the next position will be offered
automatically. You do not need to take any steps; you just need to enroll devices in the selected order.
Automatic movement to the next position can be cancelled in the device enrollment window.
−
If you enroll an already enrolled device on another position, it will move automatically.
−
If a device occupies more than one position, it will automatically occupy the respective number of
consecutive position by one enrollment (e.g. the JA-116H module, which has sixteen alarm inputs, will
occupy sixteen positions). Caution, inadvertent deletion of device enrolled on other position can occur!
−
If you enroll a device on the highest possible position, the process of gradual enrollment will be
completed.
−
Free positions are set in section 1 by default. The selection of a section can be changed later.
−
For multi-position devices such as JA-116H or JA-114HN you can limit the number of occupied positions by
erasing specific lines when the module is enrolled. Perform erasing by clicking on the particular line on
required position (Not button in column type!) and press button Delete on the PC keyboard.
