Jabiru Aircraft
Pty Ptd
Aircraft Service Manual
Jabiru J230-C
REVISION
0
Dated : Feb 2006
Issued By: RAS
Page: 91 of 171
L:\files\Technical_manuals\J230_J430\J230.J430_Work_files\J230-C_Tech_Rev_1.doc
Print Date: 14/01/2009 4:41:00 PM
Weight
5000g
+/- 100g
Hinge Moment
323300g.mm
+/- 4000g.mm
9.3.3
INSPECTION AND REPAIR
Inspect elevator for any signs of delamination or cracking. Pay particular attention to the
Control Horn and hinges and their surrounding areas.
Repairs must be referred to JABIRU AIRCRAFT Pty Ltd or our approved local agent.
9.4
CONTROL CABLE AND ATTACHMENTS
9.4.1
REMOVAL AND INSTALLATION
The Control Cable is a Primary Control and may not be repaired or removed without
reference to JABIRU AIRCRAFT Pty Ltd or our approved local agent.
9.5
RIGGING
1.
Refer to Figure 33
2.
Using the factory anchor points, make sure each end of the cable is secure.
3.
Set the full up travel first using the factory templates. Making sure the control
column is hard back. Adjust the female ball ends in or out if adjustment is needed.
4.
To establish the neutral position, align balance horn with horizontal stabiliser.
5.
Adjust cable rod ends to achieve UP and DOWN travel using the Elevator Rigging
Template (see Appendix 3).
6.
DO NOT
move the Cable Anchors – These are factory set.
7.
Ensure lock nut is tight on rod ends and that cable is visible through hole in
spherical bearing.
