Page No: 68
Issue No: 1
Date: 031100
Issued By: PJA
Drawing 9431064
Note: When gear case goes on
1)
Make sure No. 1 is 25o before T.D.C. compression.
Both valves should be seated.
2)
The rotors point to the No. 1 position on the rotor
caps.
Fit cap screws with loctite 242 and torque.
H12 a)
Fit flywheel so that magnets line up to where coils are positioned
Note: The small hole in the flywheel will line up with the hole in
the crankcase. (It may not line up with the hole in the gear
if it has been moved for cam timing.) Put loctite 262 on new
flywheel cap screws and torque to 24 nm (18 ft lbs).
b)
Fit coil mount posts and alternator mount.
c)
Fit coils and set gap to 0.25mm (0.010")
Note: A strip of 0.25mm (0.010") card is best because it is now
magnet.
Summary of Contents for 3300
