IWILL P55XB2, Manual, Page: 80 / 91

80
Remember that this setting refers to the hard disk drive itself, rather than individual
partitions. Since each IDE controller supports two separate hard drives, you can
select the INT# for each. Again, you will note that the primary has a lower interrupt
than the secondary as described in

lot x Using INT# ” above.
Selecting “
PCI Auto
” allows the system to automatically determine how your IDE
disk system is configured.
Award's ROM BIOS provides a built-in Setup program which allows user modify the
system configuration and hardware parameters. The modified data will be stored in a
battery-backed CMOS RAM, so data will be retained even the system power is off. In
general, you are not required to change any data. Unless there is a conflict or you re-
configuring system, this will need to enter new setup information. Following section
describes how to use this program and propriate entries.
The "LOAD SETUP DEFAULT" is recommended in your first time setup this system
or you change the system's configuration. You will need "LOAD SETUP
DEFAULT" first and re-confirure your system. This will be described in later chapter.
And, it is possible that battery failed which might cause data lose in CMOS RAM,
then you need to re-enter the system's CMOS RAM and re-configure to get the
suitable parameters.