IWILL DN800-L, User Manual, Page: 33 / 60

IWILL DN800-SATA/-L Series 33
Motherboard Installation
This section explains the basic requirements for installing the motherboard in a
system housing or “chassis”. Since housing designs vary widely, you will need to
consult the housing documentation for specific information.
To install the motherboard in a system housing, you will need to do the following:
• Install a rear panel I/O shield
• Attach the board to the housing
• Connect leads from the housing’s front panel
• Connect other internal system components.
Motherboard Installation Procedure
The motherboard requires installing the supplied CPU Hat Spring to mount the heat
sink retention mechanisms. Refer to the CPU Installation section in this chapter for
details.
If the housing you are using normally stands vertically, place the open housing on its
side before you start.
To install the motherboard, please follow the steps below.
1. Review any instructions that came with the system housing and prepare the
necessary mounting hardware that came with it.
2. Identify the mounting holes on the motherboard and confirm that the housing has
standoffs that match them.
3. Install the rear panel I/O shield in the housing’s I/O panel opening.
4. Place the motherboard in the housing and align the mounting holes to the
standoffs of the housing’s motherboard mounting plate. Make sure all of the rear
I/O ports are properly aligned with the openings of the I/O panel.
5. Secure the motherboard to the housing by inserting mounting screws in all the
holes.
IWILL Hardware installation