IWILL DN800-L, User Manual, Page: 30 / 60

DN800-SATA/-L Motherboard IWILL
30 IWILL DN800-SATA/-L Series
IDE and Floppy Connectors
P
RIMARY
IDE
CONNECTORS
The two 40-pin IDE connectors (primary and secondary channels) support 80-conductor
IDE ribbon cables. Connect the single connector end to the Mainboard. Then, connect the
two connectors at the other end to your IDE device(s). If you connect two hard disks to
the same cable, you must set the second drive as a Slave through its jumper settings.
Refer to the IDE device's documentation for the specific jumper settings. (Pin 20 is
removed to prevent the connector from being inserted in the wrong orientation when
using ribbon cables with pin 20 plugged in). The BIOS supports Ultra DMA 33/66/100.
F
LOPPY
D
ISK
D
RIVE
C
ONNECTOR
This 34-pin connector supports the standard floppy disk drive ribbon cable. Connect the
single connector end to the Mainboard. Then, plug the other end of the ribbon into the
floppy drive. Make sure you align the Pin 1 on the connector with the Pin 1 alignments
on the Mainboard and the floppy drive.
IMPORTANT
Ribbon cables should always be connected with the red
stripe on the Pin 1 side of the connector. IDE ribbon
cables must be less than 46 cm (18 inches) long, with the
second drive connector no more than 15 cm (6 inches)
away from the first connector.
Pin1