
DN800-SATA/-L Motherboard IWILL
16 IWILL DN800-SATA/-L Series
1
2
Jumper Setting
JP1: Clear CMOS Header
The onboard button cell battery powers the CMOS RAM. It contains all the BIOS setup
information. Keep the jumper connected to pins 1-2 (Default) to retain the RTC data as
shown below.
Under certain circumstances, you will need to reset system settings. Follow these
instructions to clear the CMOS RTC data:
1.
Turn off the computer.
2.
Short pins 2 and 3 with a jumper for a few seconds.
3.
Replace the jumper to pins 1 and 2.
4.
Turn on your computer by pressing the power-on button.
5. Hold down <F2> during boot and select either <Load Optimal Defaults> or
<Load Failsafe Defaults> in the “Exit” section. Then go through the BIOS setup
to re-enter user preferences.
1-2 2-3
Normal (Default)
Clear CMOS
3
Summary of Contents for DN800-L
