REL1.1
Page 65 of 71
iWave Systems Technologies Pvt. Ltd.
RZ/G1E SODIMM Development Platform Hardware User Guide
6.
APPENDIX I
6.1
Guidelines to insert the RZ/G1E SODIMM SOM into Carrier Board
•
Make sure that power is not provided to the SODIMM carrier board.
•
Insert the SOM module into the socket at a slight angle (approximately 25 degrees) as shown in the below
illustration (A). Note that the socket and module are both keyed, which means the module can be installed
one way only.
•
To seat the module into the socket, apply firm, even pressure to each end of the module until you feel it slip
down into the SODIMM socket connector.
•
With the module properly seated in the socket, rotate the module downward, as indicated in the illustration
(B). Continue pressing the SOM module downward until the clips at each end of the socket lock into position.
•
Once the SOM have been installed, Carrier board can be Powered ON with 5V power supply.
Figure 31: RZ/G1E SODIMM Module Insertion procedure
6.2
Guidelines to remove the RZ/G1E SODIMM SOM from Carrier board
•
Make sure that power is not provided to the Carrier board.
•
When you remove the SOM module, pull away the retention clips (A) on each side of the SOM module.
•
The module pops up. Grasp the edge of the module (B), and gently pull the module out of the connector
Figure 32: RZ/G1E SODIMM Module Removal procedure