2. Place a container under the pump and turn the pump.
3. Unscrew the other oil plug.
If this hole has the markings "oil in", raise the pump upright for a short period of time during
drainage in order to drain all the oil.
Fill with oil
The oil should be a paraffin oil with viscosity close to ISO VG32.
1. Replace the O-rings of the oil plugs.
2. Refit an oil plug in the hole that faces downwards or is marked "oil out", and tighten.
Tightening torque: 10-40 Nm (7.5-29.5 ft-lbs)
3. Fill with oil through the hole on the opposite side or the hole marked "oil in".
If the hole is marked "oil in", slightly tilt the pump and lower it again in order to fill the pump with
the correct quantity.
Quantity: approximately 1.0 liters (1.1 quarts)
Maintenance (Continued)
24
Flygt 3102 Service and Repair Instructions
