ITI ITI UltraGard, Installation Instructions Manual

Page: 48 / 64

Appendix D: System Planning Worksheets
44
Table D.5 Panel Configuration Settings
Feature Choices Default Setting
Primary Phone
Number 2 to 18 digits,
incl. pauses –
Phone Format - ITI
- 4/2, 1400Hz†
- 4/2, 2300Hz† ITI
Siren Time-out 01–30 min. 4 min.
Install Code 0001–9998 or
****(blank) ****
Account Number 00000–99999 00–000
Entry Delay 008–120 sec. 32 sec.
Extended Delay 01–08 min. 4 min.
Exit Delay 008–184 sec. 32 sec.
Activity Time-out 01–24 hr. 24 hr.
House Code 001–254 001
Freeze Temp (ESM) 40–90 ° F 42 ° F
Set Temp (ESM) 32–99 ° F –
Touchpad Options:
Unit Number 000–007 1
Touchpad Quiet Y or N N
Key Beeps Y or N Y
AVM Mode 01–03, 09–
11† 03
AVM Time-out 030–300 sec. 90 sec.
AVM Code 0001–9998* or
****(blank) ****
HOM Setup ‡
Time Zone 05 (Eastern)
06 (Central)
07 (Mountain)
08 (Pacific)
10 (Hawaii) 05
* Any four digit sequence different than primary, install,
secondary, or arm-disarm access codes, 7777, 8888,
9999, or any number of 6s. Last two digits cannot be the
same.
† If t he Phone Format is set to 4/2 1400 or 2300Hz for-
mat, upper sensor 98—Events Report must be off.
If the AVM Mode is set to instant modes 3 or 11 and the
Phone Format is set for 4/2 1400 or 2300Hz format, the
central station must be set with the panel’s account num-
ber in the ATRAP (audio trap) table. The panel will not
hang up the phone when the report is complete, but will
remain on the line for the AVM Time-out duration.
‡ For HOM setup refer to the Hardwire Output Module
(HOM) Installation Instructions document 466-1032,
included with each HOM.
Table D.6 HOM Configuration Settings
Unit
No.
Output Point Configuration Number
0 1 01
2 02
3 03
4 04
1 1 05
2 06
3 07
4 08
2 1 09
2 10
3 11
4 12
3 1 13
2 14
3 15
4 16
4 1 17
2 18
3 19
4 20
5 1 21
2 22
3 23
4 24
6 1 25
2 26
3 27
4 28
7 1 29
2 30
3 31
4 32