ITI ITI UltraGard, Installation Instructions Manual

Page: 16 / 64

Programming the Panel
12
Caution
After exiting from learning touchpads, reentering the learn
touchpads menu by pressing COMMAND automatically de-
letes all learned touchpads. When adding wireless touch-
pads to the system, you must also relearn existing
touchpads.
Programming Panel
Configuration Options
This section describes how to program the following:
• Primary phone number and phone format
• Siren time-out
• Install code
• Account number
• Entry, extended, and exit delays
• Activity time-out
• House code
• Energy Saver Module (ESM) freeze and set tem-
peratures
• Touchpad unit number, quiet, and key beeps
options
• Audio Verification Module (AVM) mode, time-
out, and code
• HOM setup
• Time zone
• User-programming system settings
• Duress code
Use the panel configuration settings you recorded in
table D.5 to program the system.
Programming the Primary
Phone Number
The panel can report alarms and all other reports to a
central monitoring station by programming the prima-
ry phone number (or central station’s phone number)
into panel memory. The default phone number is
blank (none).
To program the central monitoring station tele-
phone number:
1. In PROGRAM MODE, press BYPASS until the
display reads PHONE NUMBER.
2. Press COMMAND. The display shows [existing
phone number, if any].
3. Enter the central station receiver phone number
(up to 18 digits). If you need a pause between
digits, press POLICE for each 1-second pause
desired.
4. Press COMMAND. The display reads [new
phone number].
5. Press FIRE to exit.
Programming the Phone
Format
The phone format determines the type of communica-
tion the panel uses to report to the central monitoring
station’s receiver. The default phone format is “ITI.”
To program the panel telephone format:
1. In PROGRAM MODE, press BYPASS until the
display reads PHONE FORMAT.
2. Press COMMAND to display the currently
selected format. For example, ITI FMT.
3. Press BYPASS or STATUS to cycle to the
desired setting: SET ITI, -1400, or -2300.
Note
Phone format must be set to “ITI” for the panel to correctly
communicate with the ITI ToolBox Downloader.
4. Press COMMAND and the display reads SET
[selected format] OK.
5. Press FIRE to exit.